Ionic lattices and their properties

The ions sit in a repeating grid. That grid is why the crystals melt high, split cleanly, and light a lamp only after they dissolve.

Open matching student lesson ↗︎
20-A1.6k20-A1.1sts20-A1.1s20-A1.3s

Session outline

About 35 min one-to-one, or 45 min with a small group

  1. 1. Warm up (5 to 10 min): Ask the quick questions with notes closed.
  2. 2. Teach: Work through the lesson slides in order.
  3. 3. Coach practice: Use the student examples and try-it tasks.
  4. 4. Check: Finish with the outcome prompts below.

Warm-up questions

  • Why does dry table salt fail to light a conductivity tester, while salt water lights it?Listen for: In water the ions are free to move and carry charge. Listen for mobile ions.
  • What happens when tutors hit a salt crystal with a hammer?Listen for: It shatters along clean lines. This leads to the repeating grid and brittleness.
  • Why does salt have such a high melting point compared with sugar?Listen for: Strong attractions between ions take a lot of energy to break. Any idea of strong forces is a good start.

What to check they understood

  • 20-A1.6k

    Ask them to explain three properties of sodium chloride using its crystal lattice.

    A strong answer says the strong attractions throughout the grid give a high melting point, a shifted layer puts like charges side by side so it shatters, and it conducts only when melted or dissolved because then the ions can move.

  • 20-A1.1s

    Ask them to predict the conductivity of solid sodium chloride, molten sodium chloride and salt water, and give reasons.

    A strong answer predicts the solid stays dark because the ions are locked in place, and both the melted salt and the solution conduct because the ions can move.

Likely gaps from earlier grades

  • Students often say ionic solids conduct. Ask where the moving charges would come from in a locked crystal.

Work through the class slides

1 / 6

The same crystals, two lamp results

  • Dry sodium chloride can sit on a conductivity probe while the lamp stays dark.
  • A scoop of those same crystals dissolved in water can close the circuit.
Dry and dissolved salt lamps Dry salt leaves the lamp dark. Dissolved ions light the lamp. Same salt, two lamp results Na⁺ Cl⁻ Cl⁻ Na⁺ Dry crystal Lamp dark Na⁺ Cl⁻ Na⁺ In water Lamp on