Surface area of solids

A right cylinder's metal cover is two circles plus one rectangle, and a right cone uses the radius and the slant height.

Session outline

About 30 min one-to-one, or 35 min with a small group

  1. 1. Warm up (5 to 10 min): Ask the quick questions with notes closed.
  2. 2. Teach: Work through the lesson slides in order.
  3. 3. Coach practice: Use the student examples and try-it tasks.
  4. 4. Check: Finish with the outcome prompts below.

Warm-up questions

  • If tutors unrolled the label of a soup can, what shape would it be?Listen for: A rectangle. This sets up cylinder nets.
  • What shapes make up the outside of a closed cylinder?Listen for: Two circles and one rectangle. Listen for the net.
  • What is the slant height of a cone?Listen for: The distance from the tip down the side to the edge of the base. This sets a key term.

What to check they understood

  • M4

    Ask them to find the surface area of a closed cylinder with radius 10 cm and height 30 cm.

    A strong answer adds two circles, about 628 square centimetres, and the rectangle, about 1885 square centimetres, for about 2513 square centimetres.

  • A1

    Ask them to find the surface area of a cone with radius 3 cm and slant height 5 cm.

    A strong answer uses pi r squared plus pi r times slant height to get about 28.3 plus 47.1, or about 75.4 square centimetres.

Likely gaps from earlier grades

  • Students use the vertical height in place of the slant height. Mark both on a sketch.

Work through the class slides

1 / 7

Surface area in sheet metal work

  • A duct fabricator orders metal for a right cylinder, and a hopper builder orders metal for a right cone.
  • Students order the metal that covers the outside.
  • That cover is the surface area, including the ends when the formula counts the ends.
A cylinder duct and a cone hopper r h r s